Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
General Development
 ViewCast Forums : General Development
Subject Topic: Osprey-210 with DirectX 9.0 GraphEdit Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
cchan072
Newbie
Newbie


Joined: August 04 2004
Posts: 1
Posted: August 04 2004 at 5:03am | IP Logged Quote cchan072

HI,

  I have connected the output pin (Capture) of Osprey-210 to the input pin (VMR Input0) of Video Renderer and got the Error Message shown below when I ran the system.  My window platform is XP and DirectX9.0 SDK is installed.

Error Message:

This graph can't play. The device is not connected.

(Reture code:0x8007048f)

Would you like to give me an advice?

Thx

 
Back to Top View cchan072's Profile Search for other posts by cchan072
 
SteveL
Moderator Group
Moderator Group


Joined: December 19 2003
Location: United States
Posts: 34
Posted: August 12 2004 at 2:41pm | IP Logged Quote SteveL

You may have already discovered this, but if not you have to add the crossbar filter and wire it up to the capture filter (this filter is located in the WDM streaming crossbar devices section). The crossbar filter is an object which defines the inputs (S-Video, composite, etc.) to the card. It's required before you can render the capture pin.
Back to Top View SteveL's Profile Search for other posts by SteveL
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.1250 seconds.
� 2001 ViewCast Corporation - All Rights Reserved.